Removal Procedure
- Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Raise the window to the full up position.
- Apply masking tape around the outside handle.
- Open the outside handle rod to lock clip located on the door lock.
- Remove the outside handle bolt access tape cover (3) from the inner door panel.
- Remove the outside handle bolts (4).
- Remove the outside handle (2) and the rod (1) from the door.
Important: The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.
When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.
Notice: To avoid paint damage, protect the area surrounding the part which you are removing or installing.
Installation Procedure
- Install the outside handle (2) and rod (1) in the door.
- Install the outside door handle bolts (4).
- Install the outside handle bolt access tape cover (3) to the inner door panel.
- Install the outside handle rod into the clip
- Close the clip cover over the outside door handle rod.
- Inspect the door for proper operation.
- Remove the masking tape.
- Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 10 N·m (89 lb in).
Important: The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.
When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.