GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2000 🢒 Grand Prix 🢒 Body and Accessories 🢒 Wipers/Washer Systems 🢒 Windshield Washer Solvent Container Replacement

Removal Procedure

    Object Number: 334204 Size: SH
  1. Remove the screw from the tube assembly and the vehicle.
  2. Remove the tube with the seal from the washer solvent container.
  3. Remove the seal from the tube.

    4. Object Number: 334222 Size: SH
  4. Remove the right headlamp assembly. Refer to Headlamp Assembly or Headlamp Bulb Replacement in Lighting.
  5. Remove the front washer solvent container screw.
  6. Remove the front fender liner. Refer to Front Fender Liner Replacement .
  7. Disconnect the electrical connector and the hose from the washer pump.
  8. Remove two screws and the washer solvent container from the vehicle (the washer solvent level sensor is still connected).
  9. Disconnect the connector from the washer solvent level sensor.
  10. Remove two screws and the bracket from the washer solvent container.
  11. Remove the solvent level sensor and seal.
  12. Remove the washer pump and seal. Refer to Washer Pump Replacement .

Installation Procedure

    Object Number: 334222 Size: SH
  1. Install the washer pump and the seal. Refer to Washer Pump Replacement .
  2. Install the solvent level sensor and seal.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the bracket with two screws on the washer solvent container.

    4. Tighten
    Tighten the screws to 7 N·m (62 lb in).

  4. Connect the electrical connector to the washer solvent level sensor.
  5. Install the washer solvent container on the vehicle with two screws.

    6. Tighten
    Tighten the screws to 10 N·m (88 lb in).

  6. Connect the electrical connector and the hose to the washer pump.
  7. Install the front fender liner. Refer to Front Fender Liner Replacement .
  8. Install the front washer solvent container screw.

    9. Tighten
    Tighten the screw to 5 N·m (44 lb in).

  9. Install the right headlamp assembly. Refer to Headlamp Assembly or Headlamp Bulb Replacement in Lighting.

    10. Object Number: 334204 Size: SH
  10. Install the seal onto the tube.
  11. Install the tube with the seal on the washer solvent container.
  12. Install the tube on the vehicle with the screw.

    13. Tighten
    Tighten the screw to10 N·m (88 lb in).