Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Does the wiper keep running? | -- | Go to Step 5 | Go to Step 3 |
3 | Inspect for a short circuit condition in the pigtail wires to the wiper/washer switch assembly. Is a short circuit condition present? | -- | Go to Step 12 | Go to Step 4 |
4 | Replace the wiper/washer switch assembly. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle . Is the repair complete? | -- | -- | |
5 | Using a J 39200 , measure the voltage from connector C201 (vehicle side), terminal E2 to ground. Is the measurement greater than the specified value? | 1.0 V | Go to Step 9 | Go to Step 6 |
6 |
Is battery voltage present? | 10.5-15 V | Go to Step 7 | Go to Step 8 |
7 | Repair the short circuit to battery voltage condition in circuit 92. Is the repair complete? | -- | -- | |
8 | Replace the wiper motor cover assembly. Refer to Wiper Motor Cover Replacement . Is the repair complete? | -- | -- | |
9 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 11 | Go to Step 10 |
10 | Replace the wiper motor cover assembly. Refer to Wiper Motor Cover Replacement . Is the repair complete? | -- | -- | |
11 | Repair the short circuit to battery voltage condition in circuit 113. Is the repair complete? | -- | -- | |
12 | Repair the short circuit condition. Is the repair complete? | -- | -- |
