Tools Required

J 39232 Wiper Transmission Separater

1. Remove the wiper arm assemblies from the vehicle. Refer to Windshield Wiper Arm Replacement .
2. Remove the air inlet grille panel from the vehicle. Refer to Air Inlet Grille Panel Replacement .
3. Remove the connector from the wiper motor assembly.
4. Remove the wiper transmission assembly from wiper motor crank arm assembly using the J 39232 .



5. Remove three screws and the wiper drive system module from the vehicle.



6. Remove three screws and the wiper motor cover from the wiper motor assembly.

Tools Required

J 39529 Wiper Transmission Installer.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the wiper motor cover on the wiper motor assembly with three screws.

Tighten
Tighten screws to 2 N·m (18 lb in).




2. Install the wiper drive system module on the vehicle with three screws.

Tighten
Tighten screws to 10 N·m (88 lb in).




3. Install the wiper transmission assembly on the wiper motor crank arm assembly using the J 39529 .
4. Install the connector to the wiper motor assembly.
5. Install the air inlet grille panel on the vehicle. Refer to Air Inlet Grille Panel Replacement .
6. Install the wiper arm assemblies on the vehicle. Refer to Windshield Wiper Arm Replacement .
7. Operate the wipers and check for proper operation.