Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Turn the ignition switch to RUN.
2. Turn the wiper switch to OFF.
3. Disconnect the wiper/washer switch connector C201.

Do the wipers park?

--

Go to Step 3

Go to Step 4

Replace the wiper/washer switch assembly. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Using aJ 39200 , measure the voltage from connector C201 (vehicle side), terminal E2 to ground.

Is the measurement greater than the specified value?

1.0 V

Go to Step 6

Go to Step 5

Replace the wiper motor cover assembly. Refer to Wiper Motor Cover Replacement .

Is the repair complete?

--

Go to Wiper/Washer System Check

--

1. Reconnect the wiper/washer switch connector C201.
2. Disconnect the wiper motor connector.
3. Using aJ 39200 , measure the voltage from the wiper motor connector terminal D to ground.

Is the measurement greater than the specified value?

1.0 V

Go to Step 8

Go to Step 7

Replace the wiper motor cover assembly. Refer to Wiper Motor Cover Replacement .

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Repair the short circuit to battery voltage condition in circuit 113.

Is the repair complete?

--

Go to Wiper/Washer System Check

--