GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 G6 🢒 Engine 🢒 Engine Controls and Fuel - 3.9L 🢒 Stabilizer Shaft Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Scribe a line on the rear camber adjust bolts (both left and right).
  3. Remove the rear axle toe link. Refer to Toe Link Replacement .
  4. Remove the rear axle tie rod bracket brace. Refer to Rear Axle Tie Rod Bracket Brace Replacement.
  5. Remove the muffler. Refer to Muffler Replacement.

    6. Object Number: 1236975 Size: SH
  6. Remove the stabilizer shaft bracket bolts.
  7. Remove the stabilizer shaft insulators from the stabilizer shaft.

    8. Object Number: 1236972 Size: SH
  8. Remove the stabilizer link to knuckle bolts.
  9. Remove the stabilizer shaft.

Installation Procedure
  1. Install the stabilizer shaft.

    2. Object Number: 1236975 Size: SH
  2. Install the stabilizer shaft insulators.
  3. Install the stabilizer shaft brackets.

    4. Notice: Refer to Fastener Notice in the Preface section.

  4. Install the stabilizer shaft bracket bolts.

    5. Tighten
    Tighten the stabilizer shaft insulator bracket retaining bolts to 35 N·m (26 lb ft).


    Object Number: 1236972 Size: SH
  5. Install the stabilizer shaft links to knuckle bolts.

    6. Tighten
    Tighten the bolts to 55 N·m (41 lb ft).

  6. Install the rear axle toe link. Refer to Toe Link Replacement .
  7. Install the rear axle tie rod bracket brace. Refer to Rear Axle Tie Rod Bracket Brace Replacement.
  8. Install the muffler. Refer to Muffler Replacement.
  9. Lower the vehicle.