Headlight Leveling Inoperative - One Actuator Europe
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Do the headlamps change position? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 |
Does the test lamp illuminate? | -- | Go to Step 5 | Go to Step 4 |
4 | Locate and repair the open in the signal circuit of the headlamp switch. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 10 | -- |
5 | Connect a test lamp between terminal 1 and terminal 3 of the headlamp leveling actuator motor connector. Refer to Circuit Testing in Wiring Systems. Does the test lamp illuminate? | -- | Go to Step 7 | Go to Step 6 |
6 | Locate and repair the open in the ground circuit of the inoperative leveling actuator motor. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 10 | -- |
7 |
Does the voltmeter read less than the specified value? | 4.5 V | Go to Step 9 | Go to Step 8 |
8 | Replace the headlamp leveling actuator motor. Refer to Headlamp Motor/Actuator Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
9 | Locate and repair a poor connection or an open in the signal circuit of the headlamp leveling switch. Refer to Wiring Repairs or Connector Repairs in Wiring Systems. Did you complete the repair? | -- | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 3 |
