Did you perform the Radio/Audio System Check?

--

Go to Step 2

Go to Radio/Audio System Check

1. Turn on the radio.
2. Use the J 39916-A in order to isolate the inoperative speaker, if needed.
3. Adjust the FADE and BALANCE to the inoperative speaker.
4. Use the J 39200 in order to measure the A/C voltage from the speaker connector terminal A to B (speaker connected).

Is A/C voltage measured?

--

Go to Step 3

Go to Step 4

Replace the speaker.

Did you complete the repair?

--

Go to Radio/Audio System Check

--

Inspect the speaker circuits for an open or a short to ground.

Was an open or short to ground found?

--

Go to Step 5

Go to Step 6

Repair the open or the short to ground in the speaker circuit.

Did you complete the repair?

--

Go to Radio/Audio System Check

--

Is the vehicle equipped with UZ8?

--

Go to Step 7

Go to Step 8

Replace the audio amplifier.

Did you complete the repair?

--

Go to Radio/Audio System Check

--

Replace the radio. Refer to one of the following procedures:

Did you complete the repair?

--

Go to Radio/Audio System Check

--