Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Diagnostic System Check - Wiper/Washer

1. Disconnect the wiper motor connector C1.
2. Set the ignition switch to RUN.
3. Set the wiper switch to OFF.
4. Measure the voltage from connector C1, terminal B to ground with a DMM.

Is battery voltage present?

10.5-15 V

Go to Step 3

Go to Step 5

Check for a short to battery voltage in CKT 91.

Is a short circuit present?

--

Go to Step 6

Go to Step 4

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the replacement complete?

--

Go to Diagnostic System Check - Wiper/Washer

--

1. Disconnect the wiper motor connector C2.
2. Measure the voltage from connector C2, terminal A to ground with a DMM.

Is battery voltage present?

10.5-15 V

Go to Step 7

Go to Step 8

Repair the short circuit to battery voltage in CKT 91.

Is the repair complete?

--

Go to Diagnostic System Check - Wiper/Washer

--

Repair the short circuit to battery voltage in CKT 92.

Is the repair complete?

--

Go to Diagnostic System Check - Wiper/Washer

--

Repair the short circuit to battery voltage in CKT 196.

Is the short circuit repaired?

--

Go to Diagnostic System Check - Wiper/Washer

--