- Remove the key from the
ignition switch.
- Connect the passenger side air bag yellow connector (1)
to vehicle harness yellow connector (4) located under the passenger
seat.
- Install the connector position assurance (CPA) to the passenger
side air bag yellow connector (4).
- Connect the driver side air bag yellow connector (1) to
vehicle harness yellow connector (4) located under the driver seat.
- Install the connector position assurance (CPA) to the driver side
air bag yellow connector (4).
- Connect the passenger
(IP) fontal air bag yellow connector (2) to the vehicle harness yellow
connector (1) located above the passenger sound insulator.
- Install the connector position assurance (CPA) (4) to the
passenger yellow connector (1).
- Install the passenger sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
in Instrument Panel, Gauges and Console.
- Connect the driver fontal
air bag yellow connector (4) to the vehicle harness yellow connector (3)
located next to steering column (2).
- Install the connector position assurance (CPA) (1) to the
driver yellow connector (3).
- Install the driver sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gauges and Console.
- Rear fuse block is located
under the rear seat.
- Install the SIR fuse to the rear fuse block.
- Staying well away from all air bags, turn the ignition switch
to the ON position.
| 14.1. | The AIR BAG warning lamp will flash 7 times. |
| 14.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described. Refer to
Diagnostic System Check - SIR
.
