For 1990-2009 cars only
Removal Procedure
- For the 2.4L engine only, remove the push-in retainers from the cruise control cable cover.
- For the 2.4L engine only, remove the cruise control cable cover from the throttle body control bracket.
- Open the throttle body cam slightly.
- Disconnect the cruise control cable from the throttle body cam lever.
- Remove the cruise control cable from the throttle body bracket.
- Remove the cruise control cable from the retainer clip on the engine.
- Disconnect the cruise control cable from the cruise control module by turning the cable ¼ turn counterclockwise.
- Disconnect the cruise control cable slug from the ribbon buckle.
- Remove the cruise control cable from the engine compartment.
Installation Procedure
- Connect the cruise control cable slug to the ribbon buckle.
- Insert the cruise control cable into the cruise control module until the seal touches the module.
- Position the narrow cable tab into the narrow slot and the wide tab into the wide slot.
- Connect the cruise control cable to the cruise control module by turning the cable clockwise.
- Install the cruise control cable to the retainer clip on the engine.
- Install the cruise control cable to the throttle body bracket pressing into place until fully seated.
- Open the throttle body cam slightly.
- Connect the cruise control cable to the throttle body cam lever.
- Adjust the cruise control cable if there is any slack in the cable. Refer to Cruise Control Cable Adjustment .
- For the 2.4L engine only, position the cruise control cable cover to the throttle body control bracket.
- For the 2.4L engine only, install the push-in retainers to the cruise control cable cover.
Important: The ribbon must not be twisted.
Important: The adjuster tab must be pointing toward the front of the car after installation.
