GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Pull back the rear compartment trim on the left side. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.

  2. Object Number: 737420  Size: SH
  3. Loosen the nuts on the amplifier bracket.
  4. Remove the amplifier from the left wheelhouse, lifting up and pulling back.

  5. Object Number: 737419  Size: SH
  6. Disconnect the electrical connector from the amplifier.
  7. Remove the amplifier from the rear compartment.

Installation Procedure


    Object Number: 737419  Size: SH
  1. Connect the electrical connector to the amplifier.

  2. Object Number: 737420  Size: SH
  3. Install the amplifier to the left wheelhouse slots, sliding in and down.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 737418  Size: SH
  5. Tighten the nuts on the amplifier bracket.
  6. Tighten
    Tighten the nuts on the amplifier bracket to 10 N·m (89 lb in).

  7. Install the rear compartment trim on the left side. Refer to Rear Compartment Trim Panel Replacement in Body Rear End.