Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Wiper/Washer Schematics | |||
1 | Did you review the Wiper/Washer System Description and Operation and perform the necessary inspections? | Go to Step 2 | |
2 | Turn the ignition ON. Are the windshield washers always on? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
Disconnect the windshield wiper/washer switch connector at the multifunction switch assembly. Are the windshield washers always on? | Go to Step 4 | Go to Step 5 | |
4 | Test the windshield washer pump control circuit for a short to voltage. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 7 | Go to Step 6 |
5 | Replace the windshield wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column. Is the repair complete? | Go to Step 7 | -- |
6 | Replace the windshield wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the repair complete? | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
