Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: HVAC Schematics Connector End View Reference: Component Connector End Views | |||
1 | Did you review the Air Delivery Description and Operation and the Air Temperature Description and Operation perform the necessary inspections? | Go to Step 2 | |
2 | Operate the blower motor at each speed. Does the blower motor operate when turned to the OFF position? | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections |
3 | Remove the heater relay from the right instrument panel junction block. Does the blower motor run? | Go to Step 4 | Go to Step 5 |
4 | Repair the short to voltage in the blower motor supply voltage circuit. Refer to Circuit Testing and Wiring Repairs . Did you complete the repair? | Go to Step 9 | -- |
5 | Test that the heater relay is open between terminals 3 and 5 and that there is continuity between terminals 3 and 4. Did the relay test OK? | Go to Step 6 | Go to Step 7 |
6 | Test the heater relay control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs . Did you find and correct the condition? | Go to Step 9 | Go to Step 8 |
7 | Replace the heater relay. Refer to Blower Motor Relay Replacement . Did you complete the replacement? | Go to Step 9 | -- |
8 | Replace the blower switch. Did you complete the replacement? | Go to Step 9 | -- |
9 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
