For 1990-2009 cars only
Removal Procedure
- Unclip the heater wire harness from the headlamp tab (1).
- Unclip the heater wire harness below on the outside of the battery (2).
- On vehicles with automatic transmission, unclip the heater wire harness (1), from the main wire harness.
- On vehicles with manual transmission, unclip the heater wire harness from the main wire harness (1).
- Unclip the heater cartridge from the engine block.
Installation Procedure
- Fully seat the heater cartridge against the engine block and ensure the clip snaps in place. The final wire harness should be in the 8 o'clock position. The final retaining clip location should be in the 3 o'clock position.
- Route the wire harness along the rear of the engine aligned with the heater hose tube.
- Ensure the wire harness cartridge plug is fully seated onto the cartridge.
- Ensure the main wire harness clip is fully seated.
- On vehicles with manual transmission, route the heater wire harness (1) as shown.
- On vehicles with automatic transmission, route the heater wire harness (1), as shown.
- Tuck the heater wire harness below the junction box on the outside of the battery.
- Tuck the 110 volt heater plug in the space in between the battery and headlamp assembly (1).
- Clip the heater wire harness on the outside of the battery (2).
- Ensure that the 110 volt plug tie-strap securely holds the wire bundle and the protector cap is fully seated on the plug.
