Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling .
- Remove the instrument panel (I/P) compartment (2). Refer to Instrument Panel Compartment Replacement.
- Disconnect the I/P module connector (1).
- Remove the I/P module fasteners (2,3).
- Remove the inflatable restraint I/P module (1).
- Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.
Installation Procedure
- Install the inflatable restraint I/P module (1).
- Install the mounting fasteners (2,3) to the I/P module.
- Connect the I/P module connector (1).
- Install the I/P compartment (2). Refer to Instrument Panel Compartment Replacement.
- Enable the SIR system. Refer to SIR Disabling and Enabling .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten fasteners to 20 N·m (15 lb ft).
