The content theft deterrent (CTD) system, when armed, is designed to deter vehicle content theft by pulsing the horns and exterior lamps for approximately 30 seconds when an unauthorized vehicle entry is detected. However, the CTD System does not affect engine starting.

An unauthorized entry can be any of the following with the CTD System armed:

The components of the system are:

Important: The content theft deterrent (CTD) system can be armed with the windows or sunroof open.

Use the following procedure in order to arm the system:

1. Turn OFF the ignition.
2. Exit the vehicle.

Important: The system is not armed if the doors are locked manually. The keyless entry transmitter or the door lock switch must be used to arm the CTD system.

3. With a vehicle door open, lock the doors by pressing the LOCK button on the keyless entry transmitter or by pressing the LOCK button on the door lock switch. The system will begin the arm sequence when all doors are closed. The CTD system transition to the arm delay state when the final door is closed. The security indicator will illuminate steady when in the arm delay state.

If the keyless entry transmitter LOCK button is pressed after the vehicle doors have been closed, the system will transition directly to the arm delay state with the indicator on steady.

4. The system will arm approximately 30 seconds from the time that the system has entered the arm delay state. When the security indicator transitions to flashing slowly, the system is armed.

Alternately, if the LOCK button on the keyless entry transmitter is pressed a second time, the system will arm immediately, bypassing the 30 second delay.

Locking the vehicle may be accomplished without arming the content theft deterrent (CTD) system by locking the vehicle by using the manual door locks.

If system arming has occurred, it must be disarmed.

Important: Manually unlocking the doors does not disable the content theft deterrent (CTD) armed mode. Also, disconnecting the battery or pulling fuses does not disable the armed mode, as the BCM stores the CTD status in memory.

To disarm the CTD system perform one of the following:

The following is a description of each component used in the content theft deterrent (CTD) system:

Body Control Module (BCM)

The CTD system is an internal function of the body control module (BCM) which utilizes serial data and various switch inputs to perform CTD functions. When the BCM detects an unauthorized entry, it activates the horns and exterior lamps for 30 seconds. Following the 30-second alarm period is a 10-second time-out. The system will then re-arm.

Door Ajar Switches

The CTD system uses the door ajar switches as a status indicator to activate the alarm. The BCM receives the status of the front door ajar switches based on serial data messages from the Driver Door Module (DDM) and Passenger Door Module (PDM). The rear door ajar switches are monitored via a discrete input from each door ajar switch. If the BCM receives a ground signal from a door ajar switch when the CTD system is armed, the BCM activates the alarm.

Liftgate/Ligtglass Ajar Switch

The CTD system uses the liftgate and liftglass ajar switchs as a status indicator to activate the alarm. The liftgate/liftglass ajar switch is monitored via a discrete input from the switch. If the BCM receives a ground signal from the ajar switch when the CTD system is armed, the BCM activates the alarm.

Inputs

The BCM monitors the following inputs:

Outputs

The BCM controls the following: