GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2009 🢒 Solstice 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Exhaust Camshaft and Valve Lifter Replacement

Removal Procedure

    Object Number: 1578308 Size: SH
  1. Remove the exhaust camshaft position actuator. Refer to Camshaft Position Exhaust Actuator Replacement.

    2. Note: Remove each bolt on each cap one turn at a time until there is no spring tension pushing on the camshaft.

  2. Mark the bearing caps to ensure they are installed in the original position.
  3. Remove the bearing cap bolts.
  4. Remove the bearing caps.

    5. Object Number: 1578307 Size: SH
  5. Remove the exhaust camshaft (3).

    6. Object Number: 412194 Size: SH

    Note: Keep all of the roller followers and hydraulic adjusters in order so that they can be reinstalled in their respective locations.

  6. Remove the camshaft roller followers.

    7. Object Number: 412197 Size: SH
  7. Remove the hydraulic element adjusters.

Installation Procedure

    Object Number: 412197 Size: SH
  1. Install the hydraulic element adjusters into their bores in the cylinder head.
  2. Lubricate the hydraulic lash adjusters with GM PN 12345501 (Canadian PN 992704) or equivalent.

    3. Object Number: 412514 Size: SH
  3. Lubricate the valve tips with GM PN 12345501 (Canadian PN 992704) or equivalent.

    4. Object Number: 412194 Size: SH

    Note: Used roller followers MUST be returned to the original position on the camshaft. If the camshaft is being replaced, the roller followers actuated by the camshaft must also be replaced.

  4. Position the roller followers on the tip of the valve stem and on the lash adjuster, apply lubricate GM PN 12345501 (Canadian PN 992704) or equivalent.

    5. Object Number: 1578307 Size: SH
  5. Install the exhaust camshaft (3). Lubricate with GM PN 12345501 (Canadian PN 992704) or equivalent.

    6. Object Number: 1578308 Size: SH
  6. Install the camshaft bearing caps. Hand tighten the cap bolts.

    7. Caution: Refer to Fastener Caution in the Preface section.

  7. Tighten the bearing cap bolts in increments of 3 turns until they are seated.

    8. Tighten
    Tighten the bolts to 10 N·m (89 lb in).

  8. Install the exhaust camshaft position actuator. Refer to Camshaft Position Exhaust Actuator Replacement.