Notice: Do not use solvent of any type when cleaning the gasket surfaces on the intake manifold and the throttle body assembly, as damage to the gasket surfaces and throttle body assembly may result.

Notice: Do not use any solvent that contains Methyl Ethyl Ketone (MEK). This solvent may damage fuel system components.

1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
2. Remove the air cleaner outlet. Refer to Air Cleaner Outlet Resonator Replacement .
3. Disconnect the electronic throttle control (ETC) electrical connector (3).



4. Remove the throttle body bolts.
5. Remove the throttle body from the intake manifold.

1. Inspect the throttle body gasket and replace if necessary.

Notice: Refer to Fastener Notice in the Preface section.

2. Position the throttle body to the intake manifold.
3. Install the throttle body bolts.

Tighten
Tighten the bolts to 10 N·m (89 lb in).




4. Connect the ETC electrical connector (3).
5. Install the air cleaner outlet. Refer to Air Cleaner Outlet Resonator Replacement .
6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .