Caution: Remove all the air from the hydraulic brake system anytime the hydraulic brake system is opened for repair. The entire bleeding procedure must be followed. Failure to remove all the air in the hydraulic brake system will result in reduced braking performance and possible personal injury.

Caution: Refer to Brake Fluid Irritant Caution in the Preface section.

Notice: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in the Preface section.

Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

1. Turn the ignition switch to the OFF position.
2. If equipped with RPO LSJ, remove the throttle body air snorkel.
3. Clean the area of the brake pressure modulator valve (BPMV) around the pipe ports.
4. Clean the electronic brake control module (EBCM) to BPMV area of any accumulated dirt and foreign material.

1

Fittings, Brake Pressure Modulator Valve (Qty: 4)

Tip

Tighten
19 N·m (14 lb ft)

2

Fittings, Brake Pressure Modulator Valve (Qty: 2)

Tip

Tighten
19 N·m (14 lb ft)

3

Connector, BPMV Electrical

4

Bolt, BPMV to Mounting Bracket

Tighten
5.6 N·m (50 lb in)

5

Insulator, BPMV Mounting Bracket

Tip
Inspect both upper and lower insulators for excessive wear and/or damage. Replace the insulators if necessary.

6

Bolt, BPVM Mounting (Qty: 4)

Tip
Tighten the bolts in a criss-cross pattern.

Tighten
4.5 N·m (40 lb in)

7

Bolt, Brake Pressure Modulator Valve-to-Bracket

Tighten
5.6 N·m (50 lb in)

8

Module, Electronic Brake Control Module

Tip