- Connect the seat belt
pretensioner - RF connector (3) located under the front passenger seat.
- Install the connector position assurance (CPA) to the seat belt
pretensioner - RF connector (3).
- Connect the inflatable restraint side impact module - RF connector
(4) located under the front passenger seat.
- Install the CPA to the side impact module - RF connector (4).
- Connect the seat belt pretensioner - LF connector (3) located
under the driver seat.
- Install the CPA to the seat belt pretensioner - LF connector (3).
- Connect the inflatable restraint side impact module - LF connector
(4) located under the driver seat.
- Install the CPA to the side impact module - LF connector (4).
- Connect the inflatable
restraint IP module connector (1) located behind the RH insulator panel.
- Install the CPA to the IP module connector (1).
- Install the RH insulator panel.
- Connect the inflatable
restraint steering wheel module coil connector (2) located at the base of
the steering column.
- Install the CPA (3) to the steering wheel module coil connector
(2).
- Install the LH insulator panel.
- Install the SDM Fuse.
- Install the fuse block access cover.
- Staying well away from all inflator modules and pretensioners,
turn ON the ignition.
| 17.1. | The AIR BAG indicator will flash seven times. |
| 17.2. | The AIR BAG indicator will then turn OFF. |
- Perform
Diagnostic System Check - SIR
if the AIR BAG indicator does not operate as described.
