Removal Procedure
- Open the ashtray or the cupholder.
- Remove the following sets
of screws:
| • | Two screws from the front of the trim panel. For access to the
front screws, remove the ashtray or the cupholder. |
| • | Two screws from the bottom of the trim panel. For access to the
bottom screws, remove the console storage box. |
- Use a small, flat-bladed tool in order to remove the upper tabs
on the IP accessory trim plate from the instrument panel.
- Disconnect the electrical connectors, if equipped.
- Remove the IP accessory trim plate from the instrument panel.
Installation Procedure
- Install the IP accessory
trim plate to the instrument panel.
- Connect the electrical connectors, if equipped.
- Align the upper tabs of the IP accessory trim plate to the instrument
panel.
- Install the following sets of screws:
| • | Two screws to the front of the trim panel |
| • | Two screws to the bottom of the trim panel |
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Tighten all of the
screws.
Tighten
Tighten the screws to 2 N·m (18 lb in).
- Install the console storage box, if required.
- Install the ashtray or the cupholder, if required.
- Close the ashtray or the cupholder.
