For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to Disabling the SIR System in SIR.
- Remove the seat.
- Disconnect the electrical connectors.
- Using a flat-bladed tool, gently pry the memory seat control module from the bracket slots.
- Slide the module toward the rear of the seat.
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury
In order to avoid the above conditions, observe the following guidelines:
• Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Slide the module into the mounting bracket and push until the module is fully seated.
- Connect the electrical connectors.
- Install the drivers seat.
- Enable the SIR system. Refer to Enabling the SIR System in SIR.
- Calibrate the seat. Refer to Memory Seat Calibration .
