Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
DEFINITION: DOOR AJAR message is inoperative from one or more doors. | ||||
1 | Did you review the operation and perform the necessary inspections? | -- | Go to Symptoms | |
2 | Turn ON the ignition, with the engine OFF. During bulb check did the IP message display display the battery indicator? | -- | Go to Step 3 | Go to Step 4 |
3 | Is the DOOR AJAR message inoperative from one door only? | -- | Go to Step 5 | Go to Step 6 |
4 | Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gauges, and Console. Important: Perform the set up procedure for the IP. Did you complete the replacement and the set up procedure? | -- | Go to Step 10 | -- |
5 | Test the signal circuit of the suspect door ajar switch for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 7 |
6 | Repair the poor connection or open in the signal circuit of the door ajar switch. Refer to Wiring Repairs or Connector Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 10 | -- |
7 | Test the ground circuit of the suspect door ajar switch for a high resistance or an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 8 |
8 | Inspect for poor connections at the harness connector of the suspect door ajar indicator switch/door jamb switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 10 | Go to Step 9 |
9 | Replace the suspect door lock ajar indicator switch or door jamb switch. Refer to Front Side Door Lock Replacement or Sliding Door Rear Lock Replacement . Did you complete the replacement? | -- | Go to Step 10 | -- |
10 |
Does the IP display the DOOR AJAR message for each door? | -- | System OK | Go to Step 2 |
