Step
| Action
| Value(s)
| Yes
| No
|
1
|
- Turn the ignition switch to the LOCK position.
- Make sure the Power Sliding Door (PSD) lockout switch is in the
on position.
- Unlock the right sliding door.
- Press the PSD open/close button. This button is located in the
overhead console.
Does the PSD open/close?
| --
| Go to
Step
2
| Go to
Power Sliding Door (PSD) Diagnostic Information
in Doors
|
2
|
- Perform the keyless entry transmitter test. Refer to
Transmitter Test
.
- While observing the PSD, press once on the PSD open/close button
on the keyless entry transmitter.
Does the PSD open and close?
| --
| System OK
| Go to
Step
3
|
3
|
- Disconnect the RCDLR.
- Using a 10 amp fused jumper, connect momentarily between
the RCDLR harness connector terminal H and ground.
Does the PSD open/close?
| --
| Go to
Step
4
| Go to
Step 5
|
4
|
- Inspect the RCDLR connector for poor terminal contact. Refer to
Testing for Intermittent Conditions and Poor Connections
and
Connector Repairs
in Wiring Systems.
- If the connection is OK, replace the RCDLR. Refer to
Receiver Replacement
.
Is the repair complete?
| --
| System OK
| -
|
5
| Repair a poor connection or an open in CKT 1894.
Refer to
Wiring Repairs
and
Connector Repairs
in Wiring Systems.
Is the repair complete?
| --
| System OK
| -
|
