Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting System Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Did both turn signal indicator illuminate? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Did only one turn signal indicator illuminate? | -- | Go to Step 4 | |
4 | Observe the corresponding outside turn signal of the indicator that did not illuminate. Did the corresponding turn signal lamp illuminate? | -- | Go to Step 5 | |
5 | Test the affected turn signal indicator circuit for a high resistance or open. Refer to Circuit Testing or Connector Repairs in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 6 |
6 | Inspect the affected turn signal indicator bulb and replace if needed. Was the turn signal indicator bulb defective? | -- | Go to Step 8 | Go to Step 7 |
7 |
Important: Perform the set up procedure for the IP. Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gauges, and Console. Did you complete the replacement and the set up procedure? | -- | Go to Step 8 | -- |
8 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
