GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 910914  Size: SH

    Important: The evaporative emission (EVAP) purge valve is located on the upper intake manifold.

  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement for the 3.8L engine.
  2. Disconnect the EVAP canister purge valve purge pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
  3. Disconnect the EVAP canister purge valve electrical connector.

  4. Object Number: 911046  Size: SH
  5. Remove the EVAP purge valve bolt (2).
  6. Remove the EVAP purge valve (3).

Installation Procedure


    Object Number: 911046  Size: SH
  1. Install the EVAP purge valve (3).
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the EVAP purge valve bolt (2).
  4. Tighten
    Tighten the bolt to 12 N·m (106 lb in)

  5. Connect the EVAP canister purge valve electrical connector.

  6. Object Number: 910914  Size: SH
  7. Connect the EVAP canister purge valve purge pipe (2). Refer to Plastic Collar Quick Connect Fitting Service .
  8. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement for the 3.8L engine.