GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 910510  Size: SH
  1. Use a plastic trim tool to remove the ignition switch bezel.

  2. Object Number: 928809  Size: SH
  3. Pull the instrument panel (I/P) accessory trim plate rearward.

  4. Object Number: 928828  Size: SH
  5. Disconnect the electrical connector from the driver information display assembly.

  6. Object Number: 1203190  Size: SH
  7. Remove the driver information display screws.
  8. Remove the driver information display.

Installation Procedure


    Object Number: 1203190  Size: SH
  1. Place the driver information display on the I/P accessory trim plate.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the driver information display screws.
  4. Tighten
    Tighten the screws to 2 N·m (18 lb in).


    Object Number: 928828  Size: SH
  5. Connect the electrical connector to the driver information display.

  6. Object Number: 928809  Size: SH
  7. Press the I/P accessory trim plate to the I/P.

  8. Object Number: 910510  Size: SH
  9. Install the ignition switch bezel.
  10. Refer to Control Module References for programming and setup information.