Important: Do not attempt repairs in order to correct lock discrepancies. Replace the lock.

1. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
2. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .



3. Open the outside handle rod to lock clip located on the door lock.

The outside handle rods should be loose from the lock.

4. Remove the lock cylinder rod from the outside door handle. Refer to Door Lock Cylinder Replacement .
5. Remove the inside door handle. Refer to Front Side Door Inside Handle Replacement .



6. Remove the screws (1, 3, 2) from door lock.
7. Remove the door lock and rods through the access hole in the door inner panel.



8. Disconnect the electrical connector (2) from the lock by pulling out on the tab (1).
9. Remove the rods from the door lock.

1. Install the rods to the lock.
2. Connect the electrical connector (2) to the lock by pushing in on the tab (1).
3. Install the lock and rods through the access hole in the door inner panel.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the screws to the door lock (1, 3, 2). Install the top screw first (1), then the bottom (2) and lastly the middle screw (3).

Tighten
Tighten the screws to 10 N·m (89 lb in).




5. Install the lock cylinder rod to the outside door handle. Refer to Door Lock Cylinder Replacement .

Important: The outside handles have adjustable outside handle lock rods. This allows for adjustment of the amount of travel needed in order to operate the outside handle.

When servicing a vehicle with adjustable outside handle lock rods, remove all free play between the outside handle and the lock. Also, do not operate the outside handle before these connections are made.
6. Install the outside handle rod into the clip.
7. Close the clip over the outside handle rod.
8. Install the inside door handle. Refer to Front Side Door Inside Handle Replacement .
9. Inspect the door for proper operation.
10. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
11. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .