GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2005 🢒 Grand Prix 🢒 Vehicle Control Systems 🢒 Vehicle DTC Information 🢒 LED Indicator Replacement - Vehicle Security System

Removal Procedure
  1. Remove the garnish moldings from the left and the right windshield pillars. Refer to Windshield Pillar Garnish Molding Replacement .

    2. Notice: Use the following method to disengage the Head Up Display (HUD) retainers. Do NOT pry the retainers with a flat-bladed tool or other similar device.

    1. Disengage the I/P upper trim panel retainers on the sides of the HUD.
    2. Disengage the retainer rearward of the HUD.
    Failure to follow this method could break the tab on the HUD.


    Object Number: 1195543 Size: SH
  2. Use your fingers to lift under the edge of the instrument panel (I/P) upper trim panel adjacent to the trim clips. If equipped, disengage the trim panel retainers on the sides of the Head Up Display (HUD) first.

    3. Object Number: 1195772 Size: SH
  3. If equipped, disengage the retainer rearward of the HUD.
  4. Disengage the remaining trim panel retainers. Use clean shop towels to protect the I/P trim pad from the trim panel retainers. Lift the trim panel for access.

    5. Object Number: 928779 Size: SH
  5. Rotate the Theft LED. Remove the theft LED from the trim panel.

    6. Object Number: 929254 Size: SH
  6. Disconnect the theft LED from the electrical connector. Remove the theft LED.

Installation Procedure

    Object Number: 929254 Size: SH
  1. Connect the theft LED to the electrical connector. Align the theft LED to the opening in the trim panel. Rotate the theft LED.

    2. Object Number: 928779 Size: SH
  2. Align the I/P upper trim panel to the I/P trim pad. Press the retainers into the openings. Make sure that the wiring harness will not be pinched when the trim panel is installed.
  3. Install the garnish moldings to the right and the left windshield pillars. Refer to Windshield Pillar Garnish Molding Replacement .