GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 37088-A Fuel Line Disconnect Tool Set

Removal Procedure

    Caution: Wear safety glasses when using compressed air in order to prevent eye injury.

    Caution: Remove the fuel tank cap and relieve the fuel system pressure before servicing the fuel system in order to reduce the risk of personal injury. After you relieve the fuel system pressure, a small amount of fuel may be released when servicing the fuel lines, the fuel injection pump, or the connections. In order to reduce the risk of personal injury, cover the fuel system components with a shop towel before disconnection. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

    Caution: Place a dry chemical (Class B) fire extinguisher nearby before performing any on-vehicle service procedures. Failure to follow these precautions may result in personal injury.

    Notice: Cap the fittings and plug the holes when servicing the fuel system in order to prevent dirt and other contaminants from entering the open pipes and passages.

    Important: Always maintain cleanliness when servicing fuel system components.

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief .

  2. Object Number: 12776  Size: SH
  3. Blow dirt out of the fitting using compressed air.

  4. Object Number: 12780  Size: SH
  5. Choose the correct tool from J 37088-A for the size of the fitting. Insert the tool into the female connector, then push inward to release the locking tabs.

  6. Object Number: 12782  Size: SH
  7. Pull the connection apart.
  8. Notice: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.

  9. Using a clean shop towel, wipe off the male pipe end.
  10. Inspect both ends of the fitting for dirt and burrs. Clean or replace the components as required.

Installation Procedure


    Object Number: 12784  Size: SH

    Caution: Always apply a few drops of clean engine oil to the male pipe ends before connecting the fuel pipe fittings in order to reduce the risk of fire and personal injury. This will ensure proper reconnection and prevent a possible fuel leak. During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

  1. Apply a few drops of clean engine oil to the male pipe end.

  2. Object Number: 12786  Size: SH
  3. Push both sides of the fitting together to cause the retaining tabs to snap into place.

  4. Object Number: 12787  Size: SH
  5. Once the fitting is installed, pull on both sides of the fitting to ensure a secure connection.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  7. Inspect the fuel system for leaks by performing the following steps:
  8. 5.1. Turn ON the ignition switch for 2 seconds.
    5.2. Turn OFF the ignition switch for 10 seconds.
    5.3. Turn ON the ignition switch.
    5.4. Inspect for fuel leaks.