Rear Spoiler Replacement Without RPO WV6

1. Open the rear compartment.
2. Remove the nuts from the studs on the rear end spoiler.
3. Remove the rear end spoiler from the rear compartment lid.

1. Install the rear end spoiler to the rear compartment lid.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the nuts to the studs on the rear compartment lid spoiler.

Tighten
Tighten the rear compartment lid spoiler nuts to 6 N·m (53 lb in).

3. Close the rear compartment.

Rear Spoiler Replacement WithRPO WV6

Tools Required

J 25070 Heat Gun

1. Open the rear compartment.
2. Remove the two inner plugs from the compartment lid.



3. Remove the nuts (mastic washers) from the studs on the rear end spoiler and discard.



4. Heat the rear end spoiler mounting positions, using a heat gun J 25070 152 mm (6 inches) from the surface.

Apply the heat using a circular motion for about 30 seconds.

5. Remove the rear end spoiler from the rear compartment lid using a small plastic flat-bladed tool.
6. Remove all adhesive from the body panel using 3M™ scotch brite molding adhesive remover disk 3M™ P/N 07501 or equivalent.
7. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.

1. Using a small paint brush apply zinc-chromate primer to the spoiler stud inner and outer holes.
2. Clean the compartment lid attachment surface using with isopropyl alcohol and allow to flash off for 30 seconds.

Important: Do not touch the adhesive backing.

3. Remove the backing tape from the underside of the spoiler.
4. Install the rear end spoiler to the rear compartment lid, pressing into place until the adhesive is fully seated

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the new nuts (mastic washers) to the studs on the rear compartment lid spoiler.

Tighten
Tighten the rear compartment lid spoiler nuts to 6 N·m (53 lb in).




6. Install the two inner compartment lid plugs to the compartment lid.
7. Close the rear compartment.