Assist Handle Replacement W/out Lamp

1. Pull down on the assist handle to expose the retaining screws.
2. Remove the assist handle screws (1).
3. Remove the assist handle.

1. Position the assist handle in the vehicle.
2. Install the assist handle screws (1).

Tighten
Tighten the assist handle screws to 3 N·m (27 lb in).

Assist Handle Replacement With Lamp

1. Pull down the assist handle and remove the two screws (2).
2. Use a flat-bladed tool to remove the lamp lens.
3. Remove the two lamp screws (3).
4. Pull the handle away from the roof and disconnect the roof rail lamp electric connector.
5. Remove the assist handle from the vehicle.

1. Position the rear assist handle to the headliner.



2. Connect the roof rail lamp connector.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the lamps screws (3) assist handle screws (2).

Tighten
Tighten the lamp and assist handle screws to 3 N·m (27 lb in).