Important: When removing a power window switch, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the power window switch if a flat-bladed tool, awl, or metal object is used to remove the power window switch from the wiring harness.

Important: The front end of the mounting plate (by mirror select switch) has a hard plastic lip. The mounting plate must be slid to the rear to remove this front retaining lip.

1. Apply protective coating/tape at the rear of the front door power window switch mounting plate (right and/or left door).
2. Remove the front door power window switch mounting plate from the front door trim panel using a small, flat bladed tool, inserted at the rear of the front door mounting plate.

Press forward to release the mounting plate retainer and lift up on the plate.

3. Press down on the front end of the mounting plate to disconnect the tab. Lift out the mounting plate with the switch attached.
4. Remove the power mirror switch.
5. Disconnect the electrical connector from the front door power mirror switch.



6. Disconnect the electrical connector from the front door power window switch.
7. Remove the door lock switch.
8. Disconnect the electrical connector from the front door lock switch.

1. Install the front door power window switch tabs into the mounting plate slots, pressing in until fully seated.
2. Connect the electrical connector to the front door power window switch.
3. Install the power mirror switch.
4. Connect the electrical connector to the front door power mirror switch.
5. Install the door lock switch.
6. Connect the electrical connector to the front door lock switch.



7. Install the mounting plate tab into the front door trim panel and press down on the rear end to engage the retainer.