GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 363798  Size: SH
  1. Open the hood.
  2. Block the hood latch to prevent the hood locking until the hood release cable has been installed.
  3. Mark the hood latch to the hood latch support bracket with a grease pencil.
  4. Remove the bolts from the hood latch.
  5. Remove the hood latch from the hood latch support.

  6. Object Number: 363788  Size: SH
  7. Important: Do not crimp the hood latch release cable.

  8. Disconnect the hood latch release cable from the hood latch by squeezing the cable retainer and position aside.
  9. Remove the hood latch from the vehicle.

Installation Procedure


    Object Number: 363788  Size: SH
  1. Connect the hood latch release cable to the hood latch.

  2. Object Number: 363798  Size: SH
  3. Position the hood latch to the marks on the hood latch support bracket.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the hood latch to center support bracket bolts.
  6. Tighten
    Tighten the hood latch to center support bracket bolts to 25 N·m (18 lb ft).

  7. Adjust the hood as required. Refer to Hood Adjustment .
  8. Close the hood.