Radio/Audio System Operation-Compact Disc Player U1C
Playing the Radio
Perform one of the following
functions in order to play the radio or program the clock:
| • | Volume--Push the VOLUME button in order to turn the system
ON and OFF. |
| | Increase the volume by turning the knob clockwise |
| | Decrease the volume by turning the knob counterclockwise |
| • | Recall--Press the Recall button in order to display the time
with the ignition in the OFF position. When the radio is playing, press this
button in order to recall the station frequency. |
Finding A Station
Perform one of the following functions in order to select a station:
| • | AM-FM--Press the AM-FM button in order to switch between
AM, FM1 and FM2. The display shows the selection. |
| • | Tune--Press the Tune knob lightly so it extends. Turn the
lower knob in order to choose the radio stations. Push the knob back in when
not in use. |
| • | Seek--Press the UP or DOWN arrow in order to select the next
higher or next lower station and remain there. |
| • | Pushbuttons--The 6 numbered pushbuttons allow you to return
to the preselected stations. The customer can select 1-18 stations (6
AM, 6 FM1 and 6 FM2). |
| | Perform the following steps in order to preset the stations: |
| 2. | Press the AM-FM in order to select the band. |
| 3. | Tune in the desired station. |
| 4. | Press 1 of the 6 numbered pushbuttons until SET appears on the
display. |
Whenever the customer presses that numbered pushbutton, the station
that was set will return.
| 5. | Repeat the steps for each pushbutton. |
Setting the Tone
Perform the following functions in order to set the tone:
| • | Bass--Slide the lever UP or DOWN in order to increase or
decrease the bass. |
| • | Treb--Slide the lever UP or DOWN in order to increase or
decrease the treble. If a station is weak or noisy, decrease the treble. |
Adjusting the Speakers
Perform the following functions in order to adjust the speakers:
| • | Balance--Press the Balance knob lightly so it extends. Turn
the control behind the upper knob in order to move the sound to the left or
right speakers. The middle position balances the sound between the speakers.
Push the knob back in when not in use. |
| • | Fade--Press the Fade knob lightly so it extends. Turn the
control behind the lower knob in order to move the sound to the front or rear
speakers. The middle position balances the sound between the speakers.
Push the knob back in when not in use. |
Playing a Compact Disc (CD)
Insert a disc partially into the slot with the label side up. The player
will pull it in. The compact disc symbol will appear on the display. With
the ignition and the radio are both ON, the disc will begin playing and
CD will appear on the display next to the compact disc symbol. Press EJECT
in order to insert a disc when the ignition is OFF.
The integral CD player can play 8 cm single mini-discs. The full-size
compact discs and mini discs are loaded in the same manner.
If driving on a rough road or the temperature is very hot the disc may
not play and an E (error) and a number may appear on the radio display. If
the disc is ejected:
| • | The disc is upside down |
| • | The disc is dirty, scratched or wet |
| • | The air is very humid. Wait approximately an hour and try again. |
Perform the following functions in order to play or adjust a cassette:
| • | PREV(1)--Press this button or the SEEK down arrow in order
to go to the start of the current track if more than 8 seconds have
played. Hold the button or press it more than once, the player will continue
moving back through the disc. |
| • | NEXT(2)--Press this button or the SEEK up arrow in order
to go to the start of the next track if more than 8 seconds have played.
Hold the button or press it more than once, the player will continue moving
back through the disc. |
| • | RDM(3)--Press this button in order to hear the tracks in
random rather than in sequential order. The display will show RDM. Press RDM
again in order to turn off random play. |
| • | REV(5)--Press this button in order to quickly reverse within
a track. Release it to play a passage. The sound will be at a reduced volume.
The display will show an elapsed time. |
| • | FWD(6)--Press and hold this button in order to quickly advance
within a track. The sound will be at a reduced volume. The display will show
elapsed time. |
| • | Recall--Press this button in order to view the specific track
that is currently playing. Press recall again within 5 seconds to view
how long the track has been playing. When a new track starts to play the
track number will also appear. Press recall a third time and the time of
day will be displayed. |
| • | AM-FM--Press this button in order to play the radio when
a disc is playing. |
| • | CD/PLAY--Press this button in order to change to the disc
function when the radio is ON. |
| • | EJECT--Press this button in order to remove the disc or stop
the disc and switch to the radio. EJECT may be activated with the radio OFF.
If you leave a compact disc in the player while listening to the radio
it may become warm. |
Compact Disc (CD) Adapter Kits
Use a CD adapter kit with the cassette tape player after activating
the bypass feature on the tape player. In order to activate the bypass feature
the ignition must be in the ON position. Turn the radio OFF. Press the
TAPE/PLAY and hold for 3 seconds. After 3 seconds, the tape
symbol in the display will flash for 2 seconds indicating the bypass
feature is active. Turn the radio ON and insert the adapter. This bypass
feature will remain active until the EJECT button is pressed.
Radio/Audio System Operation-Compact Disc Player UP3
Playing the Radio
Perform one of the following
functions in order to play the radio or program the clock:
| • | Volume--Push the VOLUME button in order to turn the system
ON and OFF. |
| | Increase the volume by turning the knob clockwise |
| | Decrease the volume by turning the knob counterclockwise |
| • | Recall--Press the Recall button briefly in order to recall
the station being played or to display the clock. If you press the knob with
the ignition OFF, the clock will show for a few seconds. |
Finding A Station
Perform one of the following functions in order to select a station:
| • | AM-FM--Press the AM-FM button in order to switch between
AM, FM1 and FM2. The display shows the selection. |
| • | Tune--Press the Tune knob lightly so it extends. Turn the
lower knob in order to choose the radio stations. Push the knob back in when
not in use. |
| • | Seek--Press the UP or DOWN arrow in order to select the next
higher or next lower station and remain there. |
| • | Pushbuttons--The 6 numbered pushbuttons allow you to return
to the preselected stations. The customer can select 1-18 stations (6
AM, 6 FM1 and 6 FM2). |
| | Perform the following steps in order to preset the stations: |
| 2. | Press the AM-FM in order to select the band. |
| 3. | Tune in the desired station. |
| 4. | Press 1 of the 6 numbered pushbuttons until SET appears on the
display. |
Whenever the customer presses that numbered pushbutton, the station
that was set will return.
| 5. | Repeat the steps for each pushbutton. |
Setting the Tone
Equalizer: A 7 band equalizer is a part of the audio system. Slide the
levers up to boost or down to reduce frequency range.
Adjusting the Speakers
Perform the following functions in order to adjust the speakers:
| • | Balance--Press the Balance knob lightly so it extends. Turn
the control behind the upper knob in order to move the sound to the left or
right speakers. The middle position balances the sound between the speakers.
Push the knob back in when not in use. |
| • | Fade--Press the Fade knob lightly so it extends. Turn the
control behind the lower knob in order to move the sound to the front or rear
speakers. The middle position balances the sound between the speakers.
Push the knob back in when not in use. |
Playing a Compact Disc (CD)
Insert a disc partially into the slot with the label side up. The player
will pull it in. With the ignition and the radio are both ON, the disc will
begin playing. Press EJECT in order to insert a disc when the ignition is
OFF.
The integral CD player can play 8 cm single mini-discs. The full-size
compact discs and mini discs are loaded in the same manner.
If driving on a rough road or the temperature is very hot the disc may
not play and an E (error) and a number may appear on the radio display. If
the disc is ejected:
| • | The disc is upside down |
| • | The disc is dirty, scratched or wet |
| • | The air is very humid. Wait approximately an hour and try again. |
Perform the following functions in order to play or adjust a cassette:
| • | PREV(1)--Press this button or the SEEK down arrow in order
to go to the start of the current track if more than 8 seconds have
played. Hold the button or press it more than once, the player will continue
moving back through the disc. |
| • | NEXT(2)--Press this button or the SEEK up arrow in order
to go to the start of the next track if more than 8 seconds have played.
Hold the button or press it more than once, the player will continue moving
back through the disc. |
| • | RDM(3)--Press this button in order to hear the tracks in
random rather than in sequential order. The display will show RDM. Press RDM
again in order to turn off random play. |
| • | REV(5)--Press this button in order to quickly reverse within
a track. Release it to play a passage. The sound will be at a reduced volume.
The display will show an elapsed time. |
| • | FWD(6)--Press and hold this button in order to quickly advance
within a track. The sound will be at a reduced volume. The display will show
elapsed time. |
| • | Recall--Press this button in order to view the specific track
that is currently playing. Press recall again within 5 seconds to view
how long the track has been playing. When a new track starts to play the
track number will also appear. Press recall a third time and the time of
day will be displayed. |
| • | AM-FM--Press this button in order to play the radio when
a disc is playing. |
| • | CD/PLAY--Press this button in order to change to the disc
function when the radio is ON. |
| • | EJECT--Press this button in order to remove the disc or stop
the disc and switch to the radio. EJECT may be activated with the radio OFF.
If you leave a compact disc in the player while listening to the radio
it may become warm. |
Radio/Audio System Operation-Compact Disc Player U1S
With the optional compact
disc (CD) player, 1-12 discs can be played continuously. Normal size
discs can be played using the trays supplied in the magazine. The 8 cm
single mini-discs can be played only with the specially designed trays.
The magazine needs to be loaded with discs before playing a compact
disc. Press the button on the back of the magazine and pull gently on one
of the trays. Load the trays from bottom to top, placing a disc on the tray
label side down. If a loaded disc is label side up, the disc will not play
and an error will occur. Gently push the tray back in to the magazine slot.
Repeat this procedure for loading up to 12 discs in the magazine.
Once the discs are loaded in the magazine, slide open the door of the
CD player. Push the magazine into the player in the direction of the arrow
marked on the top of the magazine.
Close the door by sliding it all the way to the left. If the door is
left partially open the player will not operate and the error will occur.
When the door is closed, the player will begin checking for discs in the
magazine. This will continue for up to 2 minutes depending on the number
of discs loaded.
In order to eject the magazine from the player, slide the CD player
door all the way open. The magazine will automatically eject. Remember to
keep the door closed whenever possible to keep dirt and dust from getting
inside the player.
All of the CD functions are controlled by the radio buttons except for
ejecting the magazine. Whenever a CD magazine with discs is loaded in the
player, the CD symbol will appear on the radio display. If the CD player
is checking the magazine for compact discs, the CD symbol will flash on
the display until the player is ready to play. When a CD begins playing,
CD will appear in the bottom left corner and a disc and track number will
be displayed. The disc numbers are listed on the front of the magazine.
Playing a Compact Disc (CD)
Perform the following functions in order to play or adjust a CD:
| • | PREV(1)--Press this button in order to go to the start of
the current track if more than 8 seconds have played. Press PREV again
to go to the previous track on the disc. |
| • | NEXT(2)--Press this button in order to advance to the next
track on the disc. |
| • | PROG(3)--Press this button in order to select the next disc
in the magazine. If a CD cannot be played the number will be skipped when
selecting discs while using the PROG button. |
| • | RANDOM(4)--Press this button in order to enter the random
play mode. RDM will appear on the display. While in this mode the tracks will
be played in random order. Pressing PROG or SEEK while in the random mode
will scan the discs and tracks randomly. Press this button again in order
to turn off the random feature and return to normal operation. |
| • | REV(5)--Press and hold this button in order to quickly reverse
within a track. As the CD reverses, the display will show an elapsed time. |
| • | FWD(6)--Press and hold this button in order to quickly advance
within a track. As the CD advances, the display will show elapsed time. |
| • | Recall--Press this button in order to view the specific track
that is currently playing. Press RECALL again within 5 seconds to view
how long the track has been playing. EL, TM will appear on the display when
in the elapsed mode. When a new track starts to play the track number will
also appear. Press RECALL a third time and the time of day will be displayed. |
| • | SEEK--Press the SEEK down arrow button while playing a CD
in order to go back to the start of the current track if more than 8 seconds
have played. Press the SEEK button again in order for the CD player to go
back to the previous tracks. Press the SEEK up arrow and it will go to the
next higher track on the disc. |
| • | TAPE/PLAY--Press this button in order to play a CD with the
magazine loaded in the player and the radio is playing. In order to return
to the radio while the CD is playing, press AM-FM. Press the AM-FM button
in order to switch between a cassette tape and a CD if both are loaded. |
Compact Disc (CD) Adapter Kits
Use a CD adapter kit with the cassette tape player after activating
the bypass feature on the tape player. In order to activate the bypass feature
the ignition must be in the ON position. Turn the radio OFF. Press the
TAPE/PLAY and hold for 3 seconds. After 3 seconds, the tape
symbol in the display will flash for 2 seconds indicating the bypass
feature is active. Turn the radio ON and insert the adapter. This bypass
feature will remain active until the EJECT button is pressed.
