- Remove the key from the
ignition switch.
- Connect the passenger yellow 2-way connector located to the right
of the steering column.
- Install the Connector
Position Assurance (CPA) to the passenger yellow 2-way connector located to
the right of the steering column.
- Connect the driver yellow
2-way connector located at the base of the steering column.
- Install the Connector
Position Assurance (CPA) to the driver yellow 2-way connector located at the
base of the steering column.
- Install the left instrument
panel insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gauges and Console.
- Install the SIR fuse on the fuse block.
- Install the IP fuse block access door.
- Staying well away from both air bags, turn the ignition switch
to the RUN position.
| 9.1. | The AIR BAG warning lamp will flash seven times. |
| 9.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the A Diagnostic System Check - SIR
if the AIR BAG warning lamp does not operate as described.
