Tools Required

1. Install the J 28467-A .
2. Install the J 28467-90 .
3. Install the J 36462 .
4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
5. Remove the power steering gear and hang the power steering gear from the exhaust pipe. Refer to Steering Gear Replacement Power Steering System.
6. Remove the transaxle mount lower bolts. Refer to Transmission Mount Replacement in Automatic Transmission/Transaxle.
7. Remove the engine mount lower bolts. Refer to Engine Mount Replacement in Engine Mechanical - 3.1L or Engine Mount and Bracket Replacement in Engine Mechanical - 3.8L.
8. Remove the power steering lines from the right side of the frame.
9. Support the rear of the frame with a jackstand.
10. Loosen the front frame bolts. Refer to Frame Replacement in Frame and Underbody.
11. Adjust the jackstand to lower the rear of the frame.
12. Position a drain pan under the forward servo cover.



13. Remove the bolts and/or screws attaching the servo cover to the transaxle case.
14. Remove the forward servo cover.
15. Remove the forward servo cover O-ring.
16. Remove the servo piston assembly.
17. Remove the servo spring.

1. Install the servo spring.
2. Install the servo piston assembly.
3. Install the forward servo cover O-ring.
4. Install the forward servo cover.

Notice: Refer to Fastener Notice in the Preface section.

5. Install the forward servo cover attaching bolts.

Tighten
Tighten the forward servo cover attaching bolts to 11 N·m (97 lb in).

6. Remove the drain pan from under the forward servo cover.
7. Adjust the jackstand to raise the rear of the frame.
8. Install the frame bolts. Refer to Frame Replacement in Frame and Underbody.
9. Remove the support from the rear of the frame.
10. Install the power steering lines to the right side of the frame.
11. Install the engine mount lower bolts. Refer to Engine Mount Replacement in Engine Mechanical - 3.1L or Engine Mount and Bracket Replacement in Engine Mechanical - 3.8L.
12. Install the transaxle mount lower bolts. Refer to Transmission Mount Replacement in Automatic Transmission/Transaxle.
13. Install the power steering gear. Refer to Steering Gear Replacement Power Steering System.
14. Lower the vehicle.
15. Remove the J 36462 .
16. Remove the J 28467-90 .
17. Remove the J 28467-A .

Important: It is recommended that transmission adaptive pressure (TAP) information be reset.

Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
18. Reset the TAP values. Refer to Adapt Function .