GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2000 🢒 Grand Prix 🢒 Transmission/Transaxle 🢒 Automatic Transaxle - 4T65-E 🢒 Accumulator and 2-1 Manual Servo Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the oil pan. Refer to Oil Pan Replacement .
  3. Remove the filter. Refer to Automatic Transmission Fluid Filter and Seal Replacement .

    4. Object Number: 164809 Size: SH
  4. Remove the accumulator attaching bolts (131).
  5. Remove the manual 2-1 band servo cover bolts (103).

    6. Object Number: 164810 Size: SH
  6. Remove the accumulator (132).
  7. Remove the manual 2-1 band servo cover (104).

    8. Object Number: 164811 Size: SH
  8. Remove the manual 2-1 band servo (106-116).
  9. To disassemble, inspect and service the accumulator and 2-1 band manual servo, refer to the Transmission/Transaxle/Transfer Case Unit Repair Manual.

Installation Procedure

    Object Number: 164811 Size: SH
  1. Install the manual 2-1 band servo (106-116).
  2. Install the manual 2-1 band servo cover (104).

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the manual 2-1 band servo cover bolts (103).

    4. Tighten
    Tighten the manual 2-1 band servo cover bolts (103) to 24 N·m (17 lb ft).


    Object Number: 164810 Size: SH
  4. Install the accumulator (132).

    5. Object Number: 164809 Size: SH
  5. Install the accumulator attaching bolts (131).

    6. Tighten
    Tighten the accumulator attaching bolts (131) to 11 N·m (97 lb in).

  6. If removed, install the new filter seal.
  7. Install the filter. Refer to Automatic Transmission Fluid Filter and Seal Replacement .
  8. Install the oil pan. Refer to Oil Pan Replacement .
  9. Lower the vehicle.

    10. Important: It is recommended that transmission adaptive pressure (TAP) information be reset.

    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

  10. Reset the TAP values. Refer to Adapt Function .