For 1990-2009 cars only
- Remove the small seal clamp from the inner tie rod boot.
- Position the steering wheel in the straight ahead position.
- Loosen the hex nut on the tie rod (2). Turn the tie rod shaft (1) in order to obtain the proper toe angle. Refer to Wheel Alignment Specifications .
- Confirm the number of threads showing on each tie rod end is nearly equal.
- Confirm that the tie rod ends (3) are square before you tighten the lock nuts (2).
- Install the seal clamps.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the hex nuts at the tie rod ends to 68 N·m (50 lb ft).
Important: Ensure the seals do not twist.
