GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2000 🢒 Grand Prix 🢒 Engine 🢒 Engine Controls - 3.8L 🢒 Multifunction Turn Signal Lever Replacement - On Vehicle

Removal Procedure
  1. Verify that the lever is in the center of the OFF position.
  2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.

    3. Object Number: 322946 Size: SH
  3. Disable the SIR system. Refer to Disabling the SIR System in SIR
  4. Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR
  5. Remove the steering wheel. Refer to Steering Wheel Replacement .
  6. Remove the steering column trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle .
  7. Remove the wire harness straps (2) from the wire harness assembly (1) and the steering column.
  8. Disconnect the turn signal and multifunction switch assembly connector from the SIR coil assembly connector.

    9. Object Number: 306234 Size: SH
  9. Slide the turn signal and multifunction switch assembly connectors (2) out of the steering column bulkhead connector (1).

    10. Object Number: 322982 Size: SH
  10. Remove the pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
  11. Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly.

Installation Procedure

    Object Number: 322982 Size: SH
  1. Using a small flat-blade tool compress the electrical contact and move the turn signal and multifunction switch into position on the steering column.
  2. Verify that the electrical contact of the turn signal and multifunction switch rests on the turn signal canceling cam.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the turn signal and multifunction switch screws to the turn signal and multifunction switch.

    4. Tighten
    Tighten the turn signal and multifunction switch screws to 7 N·m (62 lb in).


    Object Number: 306234 Size: SH
  4. Connect the turn signal and multifunction switch connectors (2) into the steering column bulkhead connector (1).
  5. Reconnect the turn signal and multifunction switch assembly connector to the SIR coil assembly connector.
  6. Install the wire harness assembly (1) to the steering column wire harness straps (2).

    7. Object Number: 322946 Size: SH
  7. Install the steering column trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
  8. Verify that the lever is in the center or the OFF position.
  9. Install the steering wheel to the steering column. Refer to Steering Wheel Replacement .
  10. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR
  11. Enable the SIR system. Refer to Enabling the SIR System in SIR
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.