Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
2. Remove the right front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
3. Remove the nut holding the compressor hose to the accumulator.
4. Remove the compressor hose from the accumulator.
5. Remove and discard the seal washer.
6. Remove the evaporator hose nut from the accumulator.
7. Remove the evaporator hose from the accumulator.
8. Remove and discard the seal washer.



9. Remove the accumulator bracket bolt.
10. Remove the accumulator with the bracket from the vehicle.



11. Remove the accumulator from the insulator and the bracket.

1. If replacing add the required amount of new refrigerant oil to a new accumulator. Refer to Refrigerant System Capacities .
2. Install the insulator and the bracket to the accumulator .




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the accumulator bracket and bolt to the vehicle.

Tighten
Tighten the accumulator bracket bolt to 10 N·m (89 lb in).

4. Install a new seal washer. Refer to Sealing Washer Replacement .
5. Install the compressor hose assembly to the accumulator.
6. Install the compressor hose assembly nut to the accumulator.

Tighten
Tighten the nut to 25 N·m (18 lb ft).

7. Install a new seal washer. Refer to Sealing Washer Replacement .
8. Install the evaporator hose to the accumulator.
9. Install the evaporator hose nut to the accumulator.

Tighten
Tighten the nut to 25 N·m (18 lb ft).

10. Install the right front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
11. Lower the vehicle.
12. Recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging .
13. Leak test the fittings of the component using the J 39400-A .