GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 34028 Inner Tie Rod Wrench

Removal Procedure


    Object Number: 470310  Size: SH
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly from the vehicle. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Remove the rack and pinion boot. Refer to Rack and Pinion Boot Replacement .
  4. Notice: Do not change the rack bearing preload adjustment before removing the inner tie rod from the steering rack. This could cause damage to the pinion or the steering rack or both.

  5. Remove the shock dampener (2) from the inner tie rod (5).
  6. Slide the shock dampener (2) back onto the rack (1).
  7. Important: Do not hold the steering rack while removing the inner tie rod if the preload adjustment has not been changed.

  8. Remove the inner tie rod (5) from the rack assembly (1) as follows:
  9. • Place a wrench on the flats of the inner tie rod housing (4)
    • Rotate the inner tie rod housing (4) counterclockwise until the inner tie rod (5) separates from the rack.

    Object Number: 297389  Size: SH
  10. Remove the old Loctite® from the threads (2) of the rack (1) and the inner tie rod (3).

Installation Procedure

    Important: Make sure the shock dampener is on the rack before installing the inner tie rod.

    The threads must be clean prior to the Loctite® application. Check the Loctite®, or equivalent, container for expiration date. Use only enough Loctite® to evenly coat the threads.


    Object Number: 297389  Size: SH
  1. Apply Loctite® 262, or equivalent, to the inner tie rod threads (2).
  2. Install the inner tie rod (3) to the rack and pinion (1).
  3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 297392  Size: SH
  4. Install a torque wrench to the J 34028 to tighten the inner tie rod .
  5. Hold the rack (3) while tightening the tie rod (4), as shown.

    Tighten
    Tighten the inner tie rod to 100 N·m (74 lb ft).


    Object Number: 297398  Size: SH
  6. Slide the shock dampener (2) over the inner tie rod housing (3) until the front lip of the shock dampener bottoms out against the inner tie rod housing.
  7. Install the rack and pinion boot. Refer to Rack and Pinion Boot Replacement .
  8. Install the tire and wheel assembly to the vehicle. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Remove the safety stands.
  10. Lower the vehicle.
  11. Check the wheel alignment. Refer to Wheel Alignment Measurement in Wheel Alignment.