GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Refer to Brake Dust Caution in the Preface section.

  1. Inspect the fluid level in the brake master cylinder reservoir.
  2. If the brake fluid level is midway between the maximum full point and the minimum allowable level, then no brake fluid needs to be removed from reservoir before proceeding.
  3. If the brake fluid level is higher than midway between the maximum full point and the minimum allowable level, then remove brake fluid to the midway point before proceeding.

  4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Hand tighten two wheel lug nuts to retain the rotor to the hub.
  7. Important: It is not necessary to disconnect the brake hose from the caliper when replacing brake pads.

  8. Remove the rear caliper. Refer to Rear Brake Caliper Replacement .

  9. Object Number: 497759  Size: SH
  10. Remove the brake pads from the caliper bracket.

  11. Object Number: 497762  Size: SH
  12. Remove the retainer slides from the caliper bracket.

  13. Object Number: 176945  Size: SH
  14. Inspect the following parts for cuts, tears, or deterioration. Replace any damaged parts:
  15. • The disc brake mounting and hardware. Refer to Rear Disc Brake Mounting and Hardware Inspection .
    • The caliper dust boot. Refer to Brake Pad Inspection .
  16. Inspect the caliper bolts (1, 3) for corrosion or damage. If corrosion exists, use new components, including bushings, when installing the caliper. Do not attempt to polish away the corrosion.

Installation Procedure


    Object Number: 479662  Size: SH
  1. Bottom the piston into the caliper bore. Use an old brake pad or wooden block across the face of the piston. Use a C-clamp (3) over the caliper housing. Tighten the clamp slowly to drive the piston into the caliper bore. Do not damage the piston or the caliper boot.

  2. Object Number: 497762  Size: SH
  3. Install the 2 retainer slides to the caliper bracket.

  4. Object Number: 497759  Size: SH
  5. Install the rear pads to the caliper bracket.
  6. Lubricate the bolts and the bracket boots with GM P/N 18010908 silicone grease or equivalent.
  7. Install the caliper. Refer to Rear Brake Caliper Replacement .
  8. Remove the 2 hand tightened wheel lug nuts retaining the rotor to the hub.
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle.
  11. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
  12. Slowly release the brake pedal.
  13. Wait 15 seconds, then repeat steps 9 and 10 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
  14. Fill the master cylinder reservoir to the proper level. Refer to Master Cylinder Reservoir Filling in Hydraulic Brakes.
  15. Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing .