Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 | Press each button of the transmitter one at a time. Does the system operate normally? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
3 | Lock and unlock the door locks using the controls inside the vehicle. Do the locks operate properly? | Go to Step 4 | Go to Diagnostic Starting Point - Doors in Doors |
4 | Operate the rear compartment release from inside the vehicle. Does the rear compartment release operate properly? | Go to Step 5 | Go to Diagnostic Starting Point - Body Rear End in Body Rear End |
5 |
Important: Inspect that the keyless entry transmitter is the correct model for the vehicle remote system. A wrong model transmitter may pass this test, but will not activate the vehicle remote system.
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 10 | Go to Step 6 |
6 | Do any of the buttons on the transmitter sound the tone and illuminate the green light when pressed? | Go to Step 9 | Go to Step 7 |
7 | Replace the transmitter battery. Refer to Transmitter Battery Replacement . Did you complete the replacement? | Go to Step 8 | -- |
8 |
Does a tone sound and the green light illuminate on the J 43241 after each button is pressed? | Go to Step 10 | Go to Step 9 |
9 | Replace the transmitter. Did you complete the replacement? | Go to Step 10 | -- |
10 | Perform the programming procedure. Refer to Control Module References in Computer/Integrating Systems and Transmitter Programming . Did the chime sound twice? | Go to Step 12 | Go to Step 11 |
11 | Replace the remote control door lock receiver (RCDLR). Refer to Remote Control Door Lock Receiver Replacement and Control Module References in Computer/Integrating Systems. Did you complete the replacement? | Go to Step 12 | -- |
12 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
