Removal Procedure
- Place the sunshade in the full forward position.
- Remove the headlining trim finish panel as necessary. Refer to
Headlining Trim Panel Replacement
in Interior Trim.
- Disconnect the electrical connector from
the following components:
3.1. | The sunroof control switch |
3.3. | The headliner electrical harness |
Important:
• | Note the location of the wiring harness. |
• | Note the location of the tie-straps that secure the harness to the drive
cables and to the sunroof module. |
- Cut the tie-straps and remove them.
- Remove the wiring harness from the sunroof.
Installation Procedure
- Install the wiring harness to the sunroof.
- Connect the electrical connector to the following components:
2.1. | The sunroof control switch |
2.2. | The sunroof actuator |
2.3. | The headliner electrical harness |
- Install the tie-straps.
- Install the headlining trim finish panel. Refer to
Headlining Trim Panel Replacement
in Interior Trim.
- Perform the Initialization/Teach Procedure. Refer to
Sunroof Motor/Actuator Initialization/Teach Process
.
- Inspect for proper operation of the sunroof. Refer to
Sunroof Description and Operation
.