GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Notice: Do not attempt to repair the engine fuel feed pipe or the engine fuel return pipe. Replace a damaged engine fuel feed pipe or the engine fuel return pipe.

  1. Relieve the fuel system fuel pressure. Refer to Fuel Pressure Relief .
  2. Clean all engine fuel pipe connections and areas surrounding the engine fuel pipe connections before disconnecting the engine fuel pipe connections to avoid possible contamination of the fuel system.

  3. Object Number: 22507  Size: SH
  4. Disconnect the quick-connect fittings in the engine compartment. Refer to Plastic Collar Quick Connect Fitting Service .
  5. Plug the chassis fuel feed pipe and the chassis fuel return pipe as required.
  6. Remove the upper intake manifold assembly. Refer to Upper Intake Manifold Replacement in Engine Mechanical.
  7. Remove the engine compartment fuel pipe retainer bolt.
  8. Disconnect the engine fuel return pipe from the fuel pressure regulator. Discard the O-ring.

  9. Object Number: 22505  Size: SH
  10. Disconnect the engine fuel feed pipe from the fuel rail. Discard the O-ring.

Installation Procedure


    Object Number: 22507  Size: SH
  1. Lubricate the new O-ring with clean engine oil.
  2. Connect the engine fuel return pipe to the fuel pressure regulator.

  3. Object Number: 22505  Size: SH
  4. Lubricate the new O-ring with clean engine oil.
  5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Connect the engine fuel feed pipe to the fuel rail.
  7. Tighten
    Tighten the engine fuel pipe fittings to 17 N·m (13 lb ft).

  8. Install the engine compartment fuel pipe retainer bolt.
  9. Tighten
    Tighten the fuel pipe retainer bolt to 25 N·m (18 lb ft).

  10. Install the upper intake manifold assembly. Refer to Upper Intake Manifold Replacement in Engine Mechanical.
  11. Connect the quick-connect fittings in the engine compartment. Refer to Plastic Collar Quick Connect Fitting Service .
  12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
  13. Inspect for fuel leaks using the following procedures:
  14. 9.1. Turn ON the ignition, with the engine OFF for 2 seconds.
    9.2. Turn OFF the ignition for 10 seconds.
    9.3. Turn ON the ignition, with the engine OFF.
    9.4. Inspect for fuel leaks.