GM Service Manual Online
For 1990-2009 cars only

Tools Required

    • J 1859-A Steering Wheel Puller
    • J 42120 Steering Wheel Puller Legs

Removal Procedure

  1. Disable the supplemental inflatable restraint system. Refer to SIR Disabling and Enabling in SIR.
  2. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  3. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.

  4. Object Number: 442081  Size: SH
  5. Remove the steering wheel nut (1).

  6. Object Number: 649307  Size: SH

    Notice: When removing the steering wheel with the specified steering wheel puller and the steering wheel adapter legs, ensure that the left leg tab is down and the right leg tab is up. This will prevent the steering wheel and puller from binding and will prevent damage to the steering column's integrity.

  7. Remove the steering wheel using J 1859-A  (1) and J 42120  (2).
  8. Disconnect the electrical connectors (4) from the column.

  9. Object Number: 442081  Size: SH
  10. Route the electrical connectors (4) through the steering wheel opening.
  11. Remove the steering wheel (2) from the vehicle.

Installation Procedure


    Object Number: 442081  Size: SH
  1. Route the electrical connectors (4) through the steering wheel opening.
  2. Connect the electrical connector (4) to the steering column (3).
  3. Install the steering wheel on the steering column (3).
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the steering wheel nut (1) on the steering column (3).
  6. Tighten
    Tighten the nut to 37 N·m (27 lb ft).

  7. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
  8. Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  9. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.