GM Service Manual Online
For 1990-2009 cars only

BOLT TIGHTENING PROCEDURE CYLINDER HEAD BOLTS

1986 GRAND AM, FIERO, 6000 AND FIREBIRD MODELS

A new bolt tightening procedure has been developed for the 2.5L engine which improves head to block clamping force and assures more uniform tightening.

The procedure to be used is as follows:

Cylinder head bolts should be washed in solvent and dry at installation. All residual oil should be wiped from the cylinder head mating surfaces.

Apply sealing compound pt. #1052080 to threads of bolts #9 and #10.

Install all cylinder head bolts and torque to 25 N.m (18 lb. ft.) in specified sequence (See Illustration)

Repeat the sequence bringing torque to 30 N.m (22 lb. ft.) on all bolts except #9. Torque #9 to 40 N.m (29 lb. ft) .

Repeating the sequence rotate all bolts except #9, 120 degrees (two flats).

#9 bolt should be rotated 90 degrees 1/4 turn.


Object Number: 92969  Size: LF

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.