GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 G6 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 DTC B366B

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    •  Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B366B 58: Deck Lid Unlatched Left Front Sensor Circuit incorrect reaction after event

DTC B366B 59: Deck Lid Unlatched Left Front Sensor Circuit circuit/component protection time out

Circuit/System Description

S11 is part of the Rear Compartment Lid Release Switch - Front Hinge - Left assembly. The folding top control (FTC) module uses S11 to determine if the left side of the deck lid is in a reverse open position. S11 is closed and pulls the signal circuit low when the deck lid is in a reverse open position during top operation.

Conditions for Running the DTC

The FTC module is operational.

Conditions for Setting the DTC

An open or short to ground is detected on the signal circuit of S11.

Action Taken When the DTC Sets

The top is disabled.

Conditions for Clearing the DTC

The fault is no longer present and the top completes one cycle.

Diagnostic Aids
    • An open or high resistance on the low reference circuit may also cause a DTC B366A 59 to set.
    • A weak battery may cause DTC B366B 59 to set.
    • A short to B+ may damage S11.

Reference Information

Schematic Reference

Folding Top Schematics

Description and Operation

Power Folding Top Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

    •  Scan Tool Data List
    •  Scan Tool Data Definitions
    •  Scan Tool Output Controls

Circuit/System Testing
  1. Disconnect S11.
  2. Use a scan tool to monitor LF RCL Unlatched Switch.
  3. The scan tool should indicate Inactive.
    4. ⇒If scan tool does not indicate Inactive, test the signal circuit of S11 for a short to ground.
    ⇒If circuit OK, replace FTC Module.
  4. Connect a fused jumper wire between the signal circuit of S11 and ground.
  5. Use a scan tool to monitor LF RCL Unlatched Switch.
  6. The scan tool should indicate Active.
    7. ⇒If scan tool does not indicate Active, Test the signal circuit of S11 for an open or high resistance.
    ⇒If circuit OK, replace FTC Module.
  7. Test the signal circuit of S11 for a short to voltage. If circuit tests OK, replace S11.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Folding Top Control Module Replacement